February 5, 2019

When the processor reaches the temperature you set, the ACPI-aware system will be shut down. In the Acer eRecovery window, select Recovery settings and click Next 5. Follow the steps below to change the password in Acer eRecovery. Preface Before using this information and the product it supports, please read the following general information. The value is set at the factory depending on the DRAM installed. You can also set it as Manual and go into each of the sub menu to choose specific resources. Change Password Acer eRecovery and Acer disc-to-disc recovery are protected by a password that can be changed by the user.

Uploader: Fenriktilar
Date Added: 17 May 2017
File Size: 5.29 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 33028
Price: Free* [*Free Regsitration Required]

T Self-Monitoring, Analysis, aer Reporting Technology system is a diagnostics technology that monitors and predicts device performance. Restore lah backup 3. These values may not be the same as those in your system. Product name is a key part of the Icecat product title on a product data-sheet. Disabled This option is used to set video off option. Before you proceed, make sure you have turned off the system and all peripherals connected to it.

The password typed now will clear any previously entered password from CMOS memory. In the Acer eRecovery window, select Recovery settings and click Next. TM2 Bus VID This item represents the voltage of the throttled performance state that will be initiated when the on-die sensor goes from not hot to hot. Should the programs prove defective following their purchase, the buyer and not Acer Incorporated, its distributor, or its dealer assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software.


Supervisor Password has higher priority than Aspird Password.

Acer Aspire SA85 XP Home Desktop

Change these settings only if you are familiar with the chipset. Disclaimer The information in this guide is subject to change without notice. Follow the steps below to rebuild your C: Acer Incorporated makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties of merchantability or fitness for any particular purpose.

T On board device power lna support.

III Conventions The following conventions are used in this manual: Disabled When this item is enabled, the system will restart the power-saving time-out counters when any activity is detected on the floppy disk drive, serial ports, or the parallel port. It is important to back up all data files before you use this option.

Acer Aspire SA85 Windows XP Drivers | Laptop Software

Return to original state by pushing external switch button, modem ring in, keyboard and mouse for APM mode. Scer to Windows XP 2. But the data-sheet is not yet standardized by an Icecat editor.

T Load Default Settings These parameter settings can be loaded through this menu, however, the stable default values may be affected.


Windows XP Home Edition. These information aspirs necessary for troubleshooting maybe required when asking for technical support. Multiple product codes can be mapped to one mother product code if the specifications are identical.

During the disassembly process, group the screws with the corresponding components to avoid mismatches sspire putting back the components. This function is only valid for systems Delay 4 Sec. TM2 Aspir Ratio This item represents the frequency bus ratio of the throttled performance state that will be initiated when the on-die sensor goes from not hot to hot. Removing the USB Module 1. The message “The system has password protection.

Pentium 4 and Celeron are trademarks of Intel Corporation. Be aware of the arrow positions 2.

T Advancted Chipset Features The values for the chipset can be changed through this menu, and the system performance can be optimized. Users please note that under NT 4. If it fails to find a device, change the value to Manual and then s85 configure the drive by entering the characteristics of the drive in the items described below.